RBE PLUS

The RBE Plus is a modular control board capable of managing up to 5,000 users, ideal for large-scale automation systems. It supports all CAME codes, including TOP, TAM, TWIN and ROLLING CODE, using the AF43S or AF868 frequency cards.

The RBE Plus can also manage up to 8 CXN BUS selectors and 4 CAME automation systems via CRP, with 4 inputs and outputs for advanced control. It is available in 12-24 V AC/DC or 120-230 V AC versions and can be easily connected to CAME CONNECT via a gateway for remote management and monitoring.

Simplified installation

Thanks to the DIN rail mounting system, RBE Plus can be attached to the wall in seconds.

However, the box is also designed for traditional mounting (4 screws + dowels) for greater flexibility during installation, such as on uneven surfaces.

The casing has a special rear groove for easy wiring of the antenna cable.

The right frequency at your fingertips

RBE PLUS can manage up to 5,000 users via the AF43S radio frequency cards at 433.92 MHz or AF868 at 868.35 MHz. The special connector on the board allows the radio frequency card to be plugged in, simplifying installation and any maintenance.

Up to 8 CXN BUS accessories

The accessory 806XG-0110 enables allows the simultaneous management of up to 8 selectors with CAME CXN BUS technology. Code keypads, transponders or key selectors can be easily integrated into the system and up to 5,000 codes and badges can be managed.

Integration with QUICK&EASY Access

RBE PLUS is designed to be natively integrated with the QUICK&EASY Access system for temporary access management in accommodation facilities.
The ideal solution for Bed&Breakfasts, small hotels, camping sites, warehouses and many other applications. The automatic management of access codes with the QUICK&EASY Access system combined with RBE PLUS allows the use of keypads and enables a different code to be generated for each guest. The code will be valid from the check-in date/time until check-out and the guest will receive an invitation e-mail with the code to be used at the enabled gates.
The same code will be used to log in via smartphone, without the need to install any APP.

The owner/used access point can constantly monitor the event log, verify guest access and the used access point